The Mamorubot Polypropylene Build Plate is a 3d printer build plate to be used instead of glass, mirror beds or adhesive surfaces. ,it is a build plate offer consistent and reliable prints.
Can be attached directly to your glass bed using clips or tape. .
How to use your new polypropylene build plate ? ..
Note: the polypropylene build plate has different properties than a glass or mirror plate. .
1) Remove old build plate .
2) Make sure bed is level and flat in all directions .
3) Install your new polypropylene build plate and make sure it is securely fastened to the print bed. .
4) If you have a heated bed, please heat bed to normal operating temperature for 5 minutes. .
5) When bed is heated, double check for flatness..
6) Perform your leveling routine. Bed may require .adjustments to level due to differences in plate thickness.
7) Note that some adjustment to previous bed temperature settings may be required. Make test prints to verify proper adhesion..
8) Large build plate format (510mmX510mm) may require additional adjustments to the temperature..
9) Enjoy stress free printing with your new Mamorubot build plate!.
Note: If you see reduction in adhesion, please clean with Isopropyl alcohol and a clean cloth..
Suggested Bed temperatures may vary depending on filament material..
Temperature settings for different filaments: .
1. PLA:50-70℃.
2. Flexible filament: 50-70℃.
3. ABS:100-125℃ ( 110℃ is recommended ).
4. PC:100-130℃ ( 120℃ is recommended ).
5. Nylon:90-120℃ ( 110℃ is recommended ).
6. PP:100-130℃ ( 120℃ is recommended ) .
7. PETG: 50-70℃.
If the board lost better adherence after many time use, can use sand paper to improve adherence, or please feel free to contact custom service get free replacement within 1 year of order signed date.